PROGRAMMING TOOL CE.VPU1000
PROGRAMMING TOOL CE.VPU1000
This product is used to set and read various parameters stored in both the analog-addressable devices than in those of the conventional range.
The connection to the devices takes place through the base of which is equipped the programming unit for detectors or through a dedicated cable (supplied with the product) for all other devices (only for the series analog-addressable).
The user can interact with the programming unit using the keypad and display.
Through this interface the user navigates through the menu, in a series of options and commands that allow to program some parameters on the device or to read their data.
The programming tool can be used, for example, to:
- read and set the address of the analog-addressable devices
- change the setting in a temperature sensor, conventional or analogue-addressable, rate of rise to high-temperature fixed and back
- read the "analog value standard" of analog devices or "optical value" only of optical detectors or conventional multicriteria
- read the percentage of contamination present in the optical chamber of optical smoke and optical / thermal detectors, both analog-addressable and conventional
- read the firmware version of a device and other data
- program a conventional zone module
- enable or disable an input or output channel on a multi-module
- program the operating mode of a basic 32-tone siren, also with flasher
Only one device at a time can be connected to the programming tool; depending on the type of device, must be used one of two modes of connection:
- The detectors must be installed on the base of the programming tool
- All other devices (analog-addressable) must be connected to the programming unit with the supplied cable